Atomic MB-50 Especificaciones Pagina 132
- Pagina / 152
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
132
Transmitter Battery Removal
Locate the Battery Hatch on the End of the Housing:
• Apply a coin to the recessed slot of the Hatch (Fig. 120) and
turn it counter clockwise out of the Housing.
• Remove the Battery from the Battery Compartment and
discard according to local regulations governing disposal of
batteries.
Inspection
• Closely check all of the sealing surfaces for any signs of
damage that might impair proper sealing.
• Inspect the Buttons, Lens, and Housing(s) to ensure they are
not cracked or damaged.
WARNING: If damage or corrosion is found,
return your ATOM system to an Authorized
Oceanic Dealer, and DO NOT attempt to use it
until it has received factory prescribed service.
• Remove the Battery Hatch O-ring(s) and inspect them for any
signs of deterioration or deformity. DO NOT use tools to
remove the O-ring(s).
• To ensure proper sealing, O-ring replacement is highly
recommended each time a Battery is replaced.
Fig. 120 - Transmitter Battery
Hatch
- ATOM FULL LCD 2
- FCC ID: MH8A 8
- INTRODUCTION 10
- Fig. 1 - Main Time 11
- Fig. 2 - PC Interface 12
- FEATURES AND DISPLAYS 13
- Fig. 3 - Sample Messages 14
- Fig. 4 - Low Battery 17
- (Not Available) 18
- Status (Low) 18
- WATCH FEATURES 19
- Fig. 9 - Main Time Wet 20
- (24 Hour Format) 20
- Fig. 10 - Set Hour Format 21
- Fig. 11 - Set Hour 22
- Fig. 12 - Set Minute 22
- Fig. 13 - Set Year 23
- Fig. 14 - Set Month 23
- Fig. 16 - Alternate Time 24
- Fig. 15 - Set Day 24
- Fig. 17 - Set Alternate Time 26
- Fig. 18 - Countdown Timer 27
- Fig. 20 - Timer Started 28
- Fig. 19 - Set Timer 28
- Fig. 22 - Lap Recall 29
- Fig. 21 - Chronograph 29
- Fig. 23 - Daily Alarm 30
- Fig. 24 - Set Daily Alarm 31
- DIVE COMPUTER 33
- Fig. 26 - O2 Bar Graph 34
- Fig. 25 - Nitrogen Bar Graph 34
- Fig. 27 - Max O2 Exceeded 35
- Fig. 29 - Depth Displays 36
- Fig. 28 - Tank Pressure 36
- Fig. 31 - Log Mode (Date) 37
- Fig. 30 - Safety Stop 37
- SURFACE SEQUENCE AND MODES 39
- Fig. 33 - Surface Mode 40
- (Pre Dive) 40
- Fig. 34 - Surface Mode 40
- (Post Dive) 40
- Fig. 36 - Surface Mode (O2) 42
- Fig. 37 - ATOM Battery Good 43
- Fig. 38 - TMT3 Not Available 43
- Fig. 39 - Wet 44
- (DC Surface Mode) 44
- Fig. 40 - Wet 44
- (Watch Time Mode) 44
- (Air setting) 48
- Fig. 43 - Set FO2 GAS1 48
- (32% setting) 48
- Fig. 42 - Set FO2 GAS1 48
- Fig. 44 - Set FO2 GAS2 49
- (AIR setting) 49
- Fig. 45 - Set FO2 GAS2 49
- (50% setting) 49
- Fig. 46 - Set FO2 GAS3 50
- Fig. 47 - Set FO2 GAS3 50
- (100% setting) 50
- Fig. 48 - Set FO2 Default 51
- Fig. 49 - Set Receiver 52
- Fig. 50 - Set Digital Gauge 53
- Fig. 51 - Set A 54
- Fig. 52 - Set Audible Alarm 55
- Fig. 53 - Set Depth Alarm 56
- Fig. 54 - Set EDT Alarm 57
- Fig. 55 - Set TLBG Alarm 58
- Fig. 56 - Set DTR Alarm 59
- Fig. 57B - Set Turn Pressure 60
- Alarm (value) 60
- Fig. 57A - Set Turn Pressure 60
- Alarm (OFF) 60
- Fig. 58 - Set End Pressure 61
- Fig. 59 - Set PO2 Alarm 62
- Fig. 60 - Set U 63
- Fig. 61 - Set Wet Activation 64
- Fig. 62 - Set Units 65
- Fig. 63 - Set Safety Stop 66
- Fig. 64 - Set Conservative 67
- Fig. 65 - Set Backlight 68
- Duration 68
- Fig. 66 - Set Sampling Rate 69
- Fig. 67 - Set TID1 70
- Fig. 68 - Set TID2 72
- Fig. 69 - Set TID3 74
- Fig. 70 - Serial Number 76
- (of the Watch) 76
- Fig. 71 - Plan Mode 79
- Fig. 72 - Fly Mode 80
- Fig. 73 - SAT Mode 81
- Fig. 74 - Log Preview 83
- Fig. 75 - Log Nitrogen 84
- Fig. 76 - Log Oxygen 84
- Fig. 77 - History 85
- OVERVIEW OF DIVE MODE 87
- INFORMATION 87
- Fig. 79 - Link Interruption 89
- Underwater 89
- Fig. 81 - O2 Bar Graph 91
- Fig. 80 - Nitrogen Bar Graph 91
- Fig. 82 - O2 Time Remaining 92
- Fig. 82 - ATR Alarm 93
- Fig. 83 - Ascent Rate 94
- Fig. 84 - Ascent Rate Alarm 95
- DIVE MODES 97
- Fig. 87 - No Deco Alt #2 99
- Fig. 86 - No Deco Alt #1 99
- Fig. 88 - No Deco Secondary 100
- Fig. 89 - No Deco Safety 101
- Stop Main 101
- Fig. 90 - Entry into Deco 102
- Fig. 91 - Managing a Stop 102
- Fig. 92 - Deco Main 103
- Fig. 93 - Deco Alt #1 104
- Fig. 94 - Deco Alt #2 104
- Fig. 95 - Deco Secondary 105
- Fig. 96 - Conditional 105
- Violation 105
- Responsible 106
- Fig. 98 - Delayed 107
- Violation #2 107
- Fig. 97 - Delayed 107
- Violation #1 107
- Fig. 99 - Delayed 108
- Violation #3 108
- Fig. 100 - Violation Gauge 109
- Mode (Underwater) 109
- Fig. 101 - Violation Gauge 109
- Mode (on Surface) 109
- Fig. 102 - High PO2 Warning 110
- Fig. 103 - High PO2 Alarm 111
- Fig. 104 - High O2 Alarm 112
- Fig. 105 - Digital Gauge Main 113
- SWITCHING GAS MIXES 115
- Fig. 106 - Switch Gas Alert 116
- Fig. 108 - GAS 1 Switch 118
- Fig. 109 - GAS 2 Switch 118
- Fig. 110 - Switch from GAS 1 119
- Fig. 111 - Switch from GAS 2 119
- Back to GAS 1 was made 119
- Fig. 112 - GAS 3 Switch 120
- Fig. 113 - Switch from GAS 2 120
- POST DIVE MODES 121
- Fig. 114 - Transition Period 122
- Fig. 115 - Log Preview 123
- (during Transition Period) 123
- Fig. 116 - Surface Mode 123
- (after Transition Period) 123
- REFERENCE 127
- Fig. 117 - ATOM Case Back 128
- Fig. 127 -Threading 137
- Transmitter into Regulator 137
- SPECIFICATIONS 141
- SPECIFICATIONS (CONTINUED) 143
- OXYGEN EXPOSURE LIMITS 148
- (from NOAA Diving Manual) 148
- INSPECTION / SERVICE RECORD 150
- OCEANIC WORLD WIDE 151
Relacionado con productos y manuales para Amplificadores de audio Atomic MB-50
(60 paginas)
(1 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.035 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales